Lego Death Star: The 4,016-piece Classic Star Wars set 75159 Death Star was launched for VIP members on September 15 and globally on October 1.This is a reissue of the 10188 Death Star, which is approximately 95% the exact same.
It also includes Luke Skywalker (Tatooine Disguise and Final Duel), Han Solo (“Smuggler, Disguise”), Princess Leia (Dad Vader), Grand Moff Tarkin (Imperial Officer), Moff Tian Jerrod, R3–M3, 2 Stormtroopers (Royal Guards), a Death Star Droid (Death Star Troopers), and 2 Death Star Gunners.
Lego Death Star Description
Zimmer This set is similar to 10188 and contains rooms from the Death Star from Star Wars Episode IV, A New Hope and the Death Star II in Star Wars Episode VI, Return of the Jedi. This set was created to recreate the experience of playing with both Death Stars. These rooms are included in the set:
- Trash compactor
- Tractor beam power coupling
- Block for Detention
- Conference chamber.
- Superweapon firing room.
- C-3PO and R2-D2 spent a lot of time in the Death Star in Episode IV, according to Room
- Droid maintenance room
- Room for the Emperor’s Terror
- Hangar bay equipped with a miniature model of Darth Vader’s TIE Advanced
- With crane in room
- Episode IV: Chasm that Luke & Leia cross the street
- Two turrets in a room
- There is a room that houses a missile launcher as well as various guns under the super-weapon.
- There are several storage spaces on the bottom level of the set.
Features Of Lego Death Star
This item is 41 cm tall and 42 cm across. Some barrels, many smaller cans, and a pipe are parts of this level. There are two pieces of wall art, and each one has a special sticker on it. This area has two different heights.
On each side of the centre, each wall has a pair of lights and buttons. After the floor for the second level has been built, the second bag is opened. There is a red-lit loading bay, a rack of blasters, and an entrance to the turbolift, which is like an elevator and connects all the levels of the set. There are two grey and blue barrels in the landing area.
Most likely, they hold fuel. A yellow and black “caution symbol” is at the exit to this area. There is also an elevator that works that takes you up to the hangar. A pulley is on the wall between the elevator area and the rest of the floor.
The elevator can be used by pulling
on a piece of string that is attached to it.Unlike the section below, this one has walls between each room. Again, there are buttons and lights next to the shaft. Instead of going around the whole circle, the floor only goes around three-quarters of it.
The other quarter is just a long, angled connection that makes the room taller. It has many ways to get in and out, and each one has a light on both sides. On one of them, there is a big cone with clear green parts at the top.This keeps the trash compactor door from sliding out of the set.
The turbulent shaft
is where trash goes in and out of the trash compactor Both of the sides can open and shut. This room takes up one-sixth of the area of the circle. The elevator is round on the other side. On that level, there is a set of red lights at the top of the shaft.
Lego Death Star trash is also put in this section. Next to the trash compactor is a large laser made up of two lasers and a TECHNIC cannon. This piece can turn and tilt up and down. One minifigure drives the laser, but it also has a second seat.
There is also a yellow claw that one minifigure drives. On the next floor, there is a black area over where the elevators are. This is where the smaller TIE Fighter lands. There are three boxes, arrows that point to another room, and a hole for the elevator.
The room’s door has an access panel
that looks like the ones in Star Wars video games. This door slides out. Nearby are barrels and a tube. A ladder leads to a control centre with computer screens and a sliding blast door.
Lego Death Star In this area is also a window so you can see the rest of the room. In this room is also the hyper-laser, which has a control panel array that can turn and turn at different angles. A doorway with lights on either side leads from this room to the next. There is also a hole that leads down to the trash compactor and a few small steps.
A control panel operates a device here. In the last quarter of this level, there is a part that keeps minifigures from falling off the edge. Some “robot arm” parts are in front of some of the openings into the tall room. The room has stairs that lead up to a place where you can look out. This place has a chair that can turn and two blue lights that are see-through. This doorway is in a small section of its own.
From the Dagobah swamp to the Death Star, build dioramas capturing iconic Star Wars moments.#LEGO #StarWars #LEGOStarWars #DioramaCollection pic.twitter.com/oK6QrBUycg
— LEGO (@LEGO_Group) March 24, 2022
A piece with an angle that looks like a hallway leads to the “hallway piece
A gear can open the vent-covered aperture to the trash compactor compartment. Controls for this and the gate are nearby. The other gear raises a wall.
Lego Death Star Right next to this piece is a control panel.It holds people. Lasers and cameras monitor this area. The room for taking care of droids is on the top floor. It has a table, a chair, a desk, a rack for Luke and Han’s Stormtrooper helmets, the controls for the turbolift, and a rack of equipment.
It has two groups of computer screens. One of them turns and moves the superlaser up and down. On the other side, there are two big turbolaser cannons that both spin.
A hole in the wall leads to the MSE-6 Droids’ chamber. This floor has a meeting room with a wide table and seven movable chairs.The turbolift, which connects all of the floors of the station, is in the central shaft.
Read Also : Who Was Cheslie kryst? How did Cheslie kryst died | News
